Need help?Do you have a question about the Uniden UH5000 and is the answer not in the manual?
General| Modulation | FM |
|---|---|
| Power Output | 5 Watts |
| Battery | Li-ion |
| Battery Capacity | 1800 mAh |
| Channels | 80 Channels |
Details key features such as narrowband, power, LCD, scanning, duplex, CTCSS/DCS, and backlight options.
Details the buttons, controls, and LCD display on the front panel of the UH5000.
Explains the rear panel connections and microphone interface.
Explains the meaning of various indicators displayed on the LCD screen.
Lists the standard accessories provided with the UH5000 transceiver.
Lists optional accessories available for purchase for the UH5000.
Instructions for plugging the microphone into the MIC jack.
Steps for safely removing the microphone from the MIC jack.
Instructions for mounting the MIC hanger using screws.
Instructions for mounting the MIC hanger using double-sided tape.
Procedure for powering the UH5000 on and off, including voltage alerts.
Guide to adjusting the squelch level for optimal reception.
Explains squelch sensitivity levels (oF, 1-9) and their effect on signal reception.
Important note advising to select an unused channel before setting squelch.
How to use the Monitor function to receive weak signals.
Instructions on how to select different channels using the channel selector.
Steps to program and store a preferred channel as the Instant Priority Channel.
How to recall the programmed Instant Priority Channel or previous channel.
Guide to transmitting using the PTT button and microphone.
How to use the Call function to transmit a ringing tone.
Explanation of how repeaters extend radio range and duplex operation.
Compares standard simplex operation with duplex operation using a repeater station.
Explains how duplexing works, receiving on one channel and transmitting on another.
Step-by-step guide to setting up duplex mode for repeater use.
Introduction to the scan feature for searching active channels.
How to initiate scanning and change direction using the channel selector.
Procedure to stop the scanning function.
Details how Open Scan continuously scans all selected channels.
Explains Group Scan mode and Priority Watch features.
How the radio monitors the Priority Channel during scanning.
Steps to add or remove channels from the scan memory.
Guide to setting CTCSS and DCS codes for channel privacy.
How to prevent transmitting on an occupied channel.
Instructions for choosing one of the five available call tones.
How to enable or disable the Roger Beep function.
Instructions for controlling the unit's beep sounds.
Guide to selecting different backlight colours for the LCD and keys.
How to adjust the backlight brightness level.
Instructions for flipping the LCD display orientation.
Guidelines for channel use, including emergency and calling channels in Australia.
Details on the expansion to 80 channels and narrowband usage.
Explanation of interference issues with mixed wideband and narrowband radios.
Details the warranty period, terms, and limitations for the UH5000.
Lists conditions under which the warranty will not apply.
Excludes user data and outlines the warranty remedy process.
Explains consumer guarantees and procedures for warranty claims.
To Next Page
