Uniden UBC93XLT Manual

Uniden UHF, Marin Radios & Scanners Resetting Procedure
Updated on 04/11/2016
UHF Radios:
Model No: UH011
Turn the unit off, Press and hold “TSQ” & “DUP” buttons together at the same time and turn the
power back on. After 15 seconds turn power back off then turn on
Model No: UH012SX
Turn the unit off, Press and hold “INST” & “DUP” buttons together at the same time and turn the
power back on. After 15 seconds turn power back off then turn on.
Model No: UH013SX
Turn the unit off, Press and hold “INST (SET/SKIP)” & “SQ” buttons together at the same time
and turn the power back on. After 15 seconds turn power back off, then turn on.
Model No: UH015SX
Turn the unit off, Press and hold DCS/CTCSS” & “POL(MEM)” buttons together at the same
time and turn the power back on. After 15 seconds turn power back off, then turn on.
Model No: UH035
Turn the unit off, Press and hold “DUP” & “MON” buttons together at the same time and turn
the power back on. After 15 seconds turn power back off, then turn on
Model No: UH036/UH035-2
Turn the unit off, Press and hold “[channel▲] and [vol▲]” buttons together at the same time and
turn the power back on. After 15 seconds turn power back off, then turn on.
Model No: UH037
Turn the unit off, Press and hold “DUP” & “MON” buttons together at the same time and turn
the power back on. After 15 seconds turn power back off, then turn on
Model No: UH037SX-NB
Turn the unit off, Press and hold “[channel▲] and [ vol ▲]” buttons together at the same time
and turn the power back on. After 15 seconds turn power back off then on

Uniden UBC93XLT Specifications

General

Type	Handheld Scanner
Banks	10 banks
Display	LCD
Priority Scan	Yes
Modulation Types	AM, FM, WFM
Scan Speed	50 channels per second
Scan Rate	50 channels per second
Power	DC 6V
Battery	4 x AA
Frequency Steps	5 / 12.5 kHz
Service Banks	Pre-programmed service banks