14
UNIDEN UH089NB UHF CB Transceiver
Operation
Open Scan (OS) Mode
Allows continuous scanning of all selected channels.
If an active channel is found, scanning will stop on that channel.
If the received signal ceases, the unit will wait 3 seconds for the signal to
return, otherwise scanning resumes.
After transmission in scan mode, the unit will wait 20 seconds for the
signal to return, otherwise scanning resumes.
To remove the active channel from scan memory, press [MEM]
momentarily. Scanning resumes. To deactivate SCAN, press [SCAN].
NOTE
If SCAN is deactivated while on an active channel, the
UH089NB will stay on that active channel. If no channels
are active, the UH089NB will reinstate the starting channel.
NOTE
OS Mode is indicated by the absence of the GS icon.
To Next Page
Loading...
Need help?
General
