Uniden UH755 Series User Manual

14
UNIDEN UH755 HandheldUHF-CBTransceiver
Operation
Squelch
Thesquelchisusedtoeliminatetheannoyingbackgroundnoisewhen
thereisnosignalpresentonachannel.Thesquelchcircuitdoesthisby
controllingwhentheradio’sspeakerturnson,basedonthestrengthof
receivedsignals.
NOTE
Makesuretorstselectachannelnotinusebeforesetting
thesquelchinyourUH755UHF-CBradio.
TheAutoSquelchfeaturehas0-9presetsquelchlevels:
0-maxsensitivity(minsquelch):Weak(distant)signalscanopenthesquelch.
5-medsensitivity(medsquelch):Mediumandstrongsignalscanopenthesquelch.
9-minsensitivity(max/tightsquelch):Strong/nearbysignalscanopenthesquelch.
Itrequiresnoadjustment.
To set the Squelch level:
1.Press[MENU]twotimestoenterthesqeulch
 settinglist.
2.Rotatethe [CHANNEL] knoborpress[ ]
or [ ]toselectthedesiredsquelchlevel.
3.Press&hold[MENU]tosavethesetting.
4.Press&hold[MENU]again,orpress[PTT],toexitmenumode.
NOTE
Ifanincomingsignalisveryweakthereisapossibilitythat
youwillhaveachoppyorbrokenreception,duetothe
sensitivityofthesquelch.Inthiscase,adjustthesquelch
levelaccordingly.
10
SQUELCH
The squelch is used to eliminate any annoying background noise when there
are no signals present.
Think of squelch as a gate. Turn [SQ] fully
clockwise. This raises the "Squelch Gate" so high
that only the very strong signals can get through.
Turn [SQ]
fully counter clockwise until you hear a
hiss. This opens the "Squelch Gate" so that
everything gets through noise, weak signal, and
strong signals.
To set the "Squelch Gate" to the desired level, turn
[SQ] counter-clockwise until you hear noise. Then
turn the [SQ] clockwise just until the noise
stopped. Now only the desired signal can get
through.
If an incoming signal is very weak there is a
possibility that you will have a choppy or broken
reception, due to the sensitivity of the squelch.
In this case, simply rotate the [SQ] clockwise
until the weak signal is heard clearly.
Noise
Weak Signals
Medium Signals
Strong Signals
Make sure to first select a channel not in use before setting the
squelch in your UH076SX UHF-CB radio.
UH076SX

Uniden UH755 Series Specifications

General

Channels	80
Output Power	5W
Battery Type	Li-Ion
VOX	Yes
Duplex Range Extender	Yes
Keypad Lock	Yes
Display	LCD
Antenna	Detachable
Type	UHF Handheld Radio
Waterproof	IP67
Frequency Range	476.425 - 477.4125 MHz