8
Getting Started
Attaching the Battery Pack
1. Place the battery pack onto the back
Handheld UHF-CB Transceiver
of the radio. It will only t in one way.
2. Snap the battery release clip until it clicks.
Be sure the battery pack f its tightly against
the radio body.
Avoid exposing the Lithium Ion battery, attached or
CAUTION
unattached to the radio, in direct sunshine, heated cars, or
in areas with temperatures below –20°C (–4°F) or above
+60°C (+140°F).
Exposing the chemicals contained within the battery pack to
temperatures above +60 °C (+140°F) may cause the battery
to rupture, fail or reduce performance.
In case of exposure to cell contents, wash the affected area
thoroughly, and seek medical attention.
Additional battery cautions should be applied as described
on p.2.
To Attach the Belt Clip:
Slide the belt clip into the catch until it snaps into place.
UNIDEN UH835S/UH850S
To Remove the Belt Clip:
Pinch and hold the belt clip latch and then slide the belt clip up
and out of the catch.
To Next Page
Loading...
Need help?
General
