Uniformation GKTwo - 6 First Print Instructions; 6.1 Preparing the Resin

21
www.uniformation3d.com
6 First Print Instructions
Before and after each printing, examine the nFEP to ensure there are no
holes, tears, rips, obvious dents, or other imperfections. If you see
anything, please replace the FEP film with a new one to ensure no
leaking occurs.
6.1 Preparing the Resin
Always wear a mask and gloves to avoid direct skin contact with resin.
Shake the resin bottle for 1 minute, then slowly pour the resin into the
vat. DO NOT exceed the max line of 700g or you risk the possibility of
overflow and splashing.