26
www.uniformation3d.com
from the computer to the USB drive for printing.
8 FAQ and Machine Maintenance
8.1 FAQ
Models do not stick to the platform
1. Bottom exposure time is insufficient, increase the exposure time.
2. Contact area between the model and platform is small, add raft.
3. Bad leveling
Layer separation or splitting
1. There is resin residue in the tank, filter the resin and print again.
2. The lift speed is too fast
3. FEP film is not tight enough or it needs to change to a new one.
4. The printing object is hollowed without holes created. This causes
suction issues
5. The machine is not stable during printing.
Layer shift
1. Add or increase supports.
To Next Page
Loading...