27
www.uniformation3d.com
2. Reduce the lift speed.
3. The printing object is hollowed without creating holes.
Particles Left in resin vat
The exposure time is too long. Reduce the normal exposure time and
bottom exposure time.
Check if the screen has light leakage
8.2 Machine maintenance
1. Regular lubrication is needed on the z-axis, please use a light oil
2. Always remove any residue or cured pieces from the vat, use the
cleaning function to expose the full screen then remove the cured resin
sheet which will remove the residue. Do not use sharp objects to scrape
off the residues on the FEP film. An old support makes a great handle to
pull the sheet of resin
3. Do not leave resin in the vat for more than 2 days. Please filter and
store the resin properly. If the resin leaves in the vat for over 2 days,
please stir up the resin before the next print.
4. After printing, please clean the build plate Wipe thoroughly with
paper towels or wash with alcohol.
To Next Page
Loading...