24
www.uniformation3d.com
Next, carefully remove any supports your model may have. The printed
model may need post-curing to fully solidify by UV-curing box or direct
sunlight. Please refer to your specific resin instructions for the
recommended post-processing
Eventually, there will be a situation where bits of cured/hardened resin
remains in the vat after a print. Failed supports, poor model geometry,
and many other factors can cause this. Therefore, it is critical to filter
the resin in your vat if you have any suspicion that there may be cured
pieces. Failure to do this can lead to major leaks, cracked or damaged
screen, and ripped FEP.
Any residual resin on the build plate or in the vat can be wiped off with a
microfiber.
To Next Page
Loading...