Need help?Do you have a question about the Unison Research PERFORMANCE and is the answer not in the manual?
General| Operating Mode | Class AB |
|---|---|
| Weight | 25 Kg |
| Signal to Noise Ratio | 90 dB |
| Type | Integrated Amplifier |
| Valves | 2 x ECC82 |
| Inputs | 5 x Line RCA |
| Input Impedance | 47 kOhm |
| Outputs | Speaker terminals |
| Output Impedance | 4Ω, 8Ω |
| Frequency Response | 20 Hz - 30 kHz |
| Dimensions (W x H x D) | 440 x 210 x 380mm |
Check carton for transit damage. Consult dealer if damaged before operating.
Fit valves into sockets following diagrams for correct orientation. Use gentle pressure, never force.
Place unit on stable surface, away from children/pets. Ensure adequate ventilation and avoid high temperatures.
Connect sources via RCA interconnects. Ensure equipment is off. Observe correct speaker phase for connections.
Verify local power supply voltage matches unit's requirement before connecting the mains cable. Check fuse rating.
Unit has a 5-second standby after switching on. Outputs enabled after valve warm-up. Subwoofer output enabled after 60s.
Set volume to minimum before switching on. Adjust volume after warm-up using front panel or remote handset.
Select input using front panel or remote control. Active input is indicated by a lit LED on the front panel.
Control volume and input selection via IR remote handset. Follow pairing instructions for the wood remote.
Wait approx. 5 minutes after switching off before switching on again to allow valves to cool down.
Do not open amplifier (high voltages). Avoid spills. Insert mains plug with unit off. Remove plug for long periods.
Clean only when switched off and valves are cold. Use a soft dry cloth. Do not use solvents or rub hard.
Replace valves only when cold and unit is off. Use same type, preferably matched pairs. Avoid shocks and vibration.
Dispose of product separately from other waste at designated collection centres or return to retailer as per EC directives.
To Next Page
