2. Adjust the legs in order to put the level bubble in the middle of the black circle, as in the
image.
Note: each time you move your eVscope, we recommend resetting the level bubble.
!
3. Loosen the 2 tripod screws. Install your eVscope vertically on the tripod and tighten the "
screws. Be careful not to tighten it too hard.
4. Start the eVscope by pressing the On button for 2 seconds. When you see a red light, "
the eVscope is on and ready to use. "
Warning : if you turn on your eVscope in daylight, you might not see the button light "
because of its low intensity. It has been set up like this so it won’t dazzle you at night. "
"
Battery is not fully charged when shipped.
To Next Page
Loading...
