Enhanced Vision stops
The Enhanced Vision mode stops or does not work. You may receive one of the following
messages:
- “Major impact detected – Please check and realign the level.” A major impact has been
detected (e.g., a kick to the tripod). Readjust your bubble level and follow the focusing
procedure, as explained in the quick start guide.
- “Too close to zenith – Please realign to a lower altitude.” The telescope
is close to the zenith position. Follow the focusing procedure.
- During your observation, you may see the message “Enhanced Vision abandoned.” One of
the images cannot be saved due to its poor quality and should be disregarded in order to
preserve the quality of your observation.
Two specic messages may appear :
- “Enhanced Vision abandoned. Vibration detected.”: A minor impact was detected (e.g.,
bump to the eyepiece or a gust of wind).
- “Enhanced Vision was interrupted. Too bright.”: An image was polluted by
light (e.g., nearby ashlight or smartphone)
Data download failed
In 8 instances out of 10, there is a typo in the network name (SSID) or password, but there
may be other factors causing this problem. For example, the maximum number of devices
allowed on the network has been reached, there is MAC ltering in place, or there is a WiFi
channel incompatibility. In the case of a WiFi channel incompatibility, simply restart the WiFi
connection on your router/device to resolve the problem. For the other two problems, you
will need to log into your home WiFi network using another device to enable other devices
or add the eVscope’s MAC address to the list.
5 ashes: 81% - 100% remaining to download
4 ashes: 61% - 80% remaining to download
3 ashes: 41% - 60% remaining to download
2 ashes: 21% - 40% remaining to download
1 ashes: 1% - 20% remaining to download
User guide | 31
English
To Next Page
Loading...
