Unitech MS100 User Manual

10
MS100 Manual
Data Direction
Three options are available for data direction: “Send to Host”,
“Send to Host & Terminal”, and “Send to Terminal”.
Default is “Send to Host”.
Time Out
The ACK/NAK function (see page 9) can be given a limited (ranging
from 1 second to 10 seconds) or unlimited amount of time to operate.
Default is “1 Second”.
RS232, continued
Receive Terminator
A user-definable Receive Terminator can be inserted at the end of
bar code data. Pre-defined receive terminators include:
The above special characters must be bracketed by < > symbols as
shown.
Function codes (F keys, cursor up, Enter, etc.) can also be inserted
via hexadecimal code (accessable in a linked menu) and must
include surrounding brackets (<>).
Letters and numbers should be entered directly by keyboard input
without surrounding brackets (<>).
Default is “None”.
<t>: Tab
•
<r>: Carriage Return
•
<n>: Line Feed
•
<d>: Any Digit
•
<a>: Any Letter
•
<*>: Interblock Delay
•
<“>: “ (quotation marks)
•
<dd>: character in hexadecimal notation
•
<<>: <
•
<>>: >
•

Unitech MS100 Specifications

General

Wavelength	660 nm
Sensor type	Photo diode
Tilt reading angle	45 - 90 °
Dimensions (WxDxH)	140 x 30 x 23 mm
Cable length	1.80 m
Standard interfaces	RS-232
Power consumption	800 mA
Power requirements	5V DC
Product color	Black, Blue
Housing material	Plastic
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Weight	76.5 g