C
ODE
T
YPES AND
D
ECODE
R
ULES
A
ZTEC
Enable Aztec Structure
Append Decoding
* Disable Aztec Structure
Append Decoding
³100611
³100601
When this feature is enabled, Aztec barcodes with a structured append header will be
stored in the scanner’s memory buffer. The scanner will transmit the concatenated
message once every component of the structured append barcode has been read. Up
to 16 components can be stored.
If this feature is disabled, Aztec barcodes with structured append header will be
read as normal Aztec barcodes. However, in this case, the structured append
header will be sent as part of the barcode data.
Code Select and structured append features cannot be used
concurrently. If both CodeSelect and structured append are enabled,
CodeSelect feature will not work.
The CodeSelect timeout setting determines how much time will be
allowed between individual components of the same barcode
(similar to CodeSelect operation).
By default, the scanner will emit an intermediate beep when each component is
scanned. When only one scan buffer is enabled, the user will be required to release the
trigger after reading each barcode component.
* Enable Intermediate Beep Disable Intermediate Beep
³100611
³100601
If the “intermediate beep” is disabled and the number of scan buffers is
increased – all components of a structured append barcode can be read
with a single trigger activation, and only one audible beep will be
produced, as if a regular barcode was scanned.
* Factory Default Configuration
36
To Next Page
Loading...
Need help?
General
