Unitech MS912+ - Page 16

- 29 -- 30 -
When quantity input is enabled, the operation procedure under
memory mode will be:
1. Scan [ MEMORY MODE ] (page 24)
2. Include <Quantity> in DATA FORMAT (page 26). For example,
your data format is <Barcode Data>, <Quantity>.
3. Scan a desired barcode; it will be stored as <Barcode Data>.
4. Scan [
SET QUANTITY ] below.
5. Scan numeric barcodes (range: 1 - 99999) on page 9 &10 ;
it will be stored as <Quantity>.
6. Scan [
SET QUANTITY ] again.
7. Scan [ SAVE DATA ] below.
8. Repeat Step 3 -- 7 to until your task is completed.
9. Retrieve stored data (BARCODE.txt), as instructed on page 24.
. R017$
ENABLE QUANTITY INPUT
QUANTITY
. R015$
SET QUANTITY
. R016$
SAVE DATA
. R018$
DISABLE QUANTITY INPUT
QUANTITY
When quantity input is disabled, the operation procedure under
memory mode will be:
1. Scan [
MEMORY MODE ] (page 24)
2. Set DATA FORMAT (page 26) as appropriate. For example, your
data format is <Barcode Data>, <Quantity>.
3. Scan a desired barcode; it will be stored as <Barcode Data>
4. Repeat Step 3 until your task is completed.
5. Retrieve stored data (BARCODE.txt), as instructed on page 24.