Unitech PA500 Quick Reference Guide

Copyright 2007 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Charging the PA500
IMPORTANT! For initial use, you need to charge your device for about 16 hours. After that,
you can charge it everyday to recharge the battery to full capacity. You can charge your
device using the USB charging cable or the docking station.
CAUTION: Operating the PA500 for the first time without the AC adapter, and without fully
charging the backup battery may result in loss of data stored in RAM memory.
1 Press and hold the connector button on the USB chargingcable and connect it to
the PA500.
2 Plug the AC adapter cable into the power jack on the USB charging cable.
3 Connect the AC adapter into an electrical outlet. The connection is secure when the
LED indicator on the front panel of the device lits up red.
5
English

Unitech PA500 Specifications

System Memory

SDRAM	64 MB
Flash ROM	64 MB

Display

display resolution	240x320 QVGA
display type	Color Transflective TFT
touch screen	yes

Laser Bar Code Scanner

scan rate	104 scans/sec ± 12 scans/sec
scan angle default	47°±3°
scan angle reduced	35°±3°

Power

main battery voltage	3.7 V
main battery capacity	2200 mAh
rechargeable time	3.5 hours

Operating Environment

operating temperature	32°F to 122°F (0°C to 50°C)
storage temperature	-4°F to 140°F (-20°C to 60°C)
relative humidity	5% ~ 95% (non-condensing)

Weight and Dimensions

weight with battery and scan engine	Under 213 g
length	126 mm
height	23 mm