Unitronics Jazz JZ10-11-R16L - User Manual

Unitronics 1
Jazz™ OPLC ™
Micro-OPLC Installation Guide
JZ10-11-R16L
6 Digital, 2 Analog/Digital, 2 Analog Inputs, 6 Relay Outputs
 Before using this product, the user must read and understand this document.
 For additional information regarding this product, refer to the user guide and technical specifications.
 All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
 Please dispose of this product according to local and national standards and regulations.
 Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property damage.
 Do not attempt to use this device with parameters that exceed permissible levels.
 To avoid damaging the system, do not connect/disconnect the device when power is on.
Environmental Considerations
 Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration.
 Ventilation: 10mm space required between the OPLCs’ top/bottom edges & enclosure walls.
 Do not place in water or let water leak onto the unit.
 Do not allow debris to fall inside the unit during installation.
Mounting
Dimensions
8
5
.
7
m
m
(
3
.
3
7
4
"
)
113.7 mm (4.476")
13.2 mm (0.52")
16.8 mm (0.661")
46.6 mm (1.835")
4 mm (0.157")
7.5 mm (0.295")
12 mm (0.472")
147.5 mm (5.807")
117 mm (4.606")
Add-on modules
Take into account that installing an add-on module requires sufficient clearance space.
During installation After installation
72 mm (2.835")
27.5 mm
(1.083")
3
8
m
m
(
1
.
4
9
6
"
)
3
5
.
8
m
m
(
1
.
4
0
9
"
)

Unitronics Jazz JZ10-11-R16L Specifications

General

Model	JZ10-11-R16L
Series	Jazz
CPU	16-bit
Input Voltage	24V DC
Communication Ports	RS-232, RS-485
Programming Software	Unitronics VisiLogic
Type	Programmable Logic Controller
Display	LCD

Summary

Environmental Considerations

Mounting

Dimensions

Physical dimensions and mounting hole details for the OPLC unit.

Add-on Modules Clearance

Clearance space requirements for installing add-on modules.

Installation and Wiring

Mounting Methods

Details for DIN-rail and panel mounting procedures, including cut-out dimensions.

Wiring Best Practices

Safety precautions, torque limits, and terminal wiring instructions.

Inputs

I;O Configuration

Digital Inputs Wiring

Wiring configurations for digital inputs, including npn/pnp options and controller power.

Digital Outputs Wiring

Wiring diagrams for connecting digital outputs to AC and DC loads.

Contact Life Span

Increasing Contact Life

Methods to extend contact life and protect the unit from reverse-EMF.

Analog Inputs

Analog Input Wiring

Wiring configurations for analog inputs, covering current and voltage types.