12
CHECKING THE CODES
If you have set up the Atlas XL Universal Remote Control
using the Searching For Your Code procedure (on the pre-
vious page),you may need to find out which four-digit
code is operating your equipment.For example, to find
out which code is operating your TV:
1. On the remote control,press TV once.
Then press and hold SETUP until the
TV key blinks twice,then release SETUP.
2. Enter 9 - 9 - 0.The TV key will blink twice.
3. To view the code for the first digit,press 1
once.Wait 3 seconds and count the number
of times the TV key blinks (e.g., 3 blinks = 3)
and write down the number in the leftmost
TV Code box (see below).
NOTE: If a code digit is “0”, the selected mode key
will not blink.
4. Repeat step 3 three more times for the
remaining digits. Use 2 for the second digit,
3 for the third digit, and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes below.
5. To check for other device codes,repeat steps
1 through 4, but substitute the appropriate key
(i.e., AUD or VCR) for the (Audio or VCR)
device you are checking.Write down the
codes in the appropriate boxes below.
AUD Code
VCR Code
TV Code
To Next Page
Loading...
