28
CHANGING VOLUME LOCK
On the Atlas Universal Remote Control,Global Volume Lock
is set to TV, so you can control TV volume while in the TV,
VCR,or Cable mode.If desired,you can still perform
Individual Volume Unlock on a selected device to set its
volume control for independent operation.
NOTE: If you lock the volume controls to the AUDIO mode, you will
still have control of the audio device’s volume in all other modes
(i.e., TV,VCR,and CBL).
To Unlock Volume Control For A Single Device
(Individual Volume Unlock):
1. Assuming Global Volume Lock is active,select a
mode on the remote control that you want to
unlock (e.g.,CBL) and press it once. Next, press
and hold SETUP until the device key blinks
twice, then release SETUP.
2. Enter 9 - 9 - 3.
3. Press VOL– once. The selected device key (in
step 1) will blink four times.
4. Repeat steps 1 through 3 (of this section) for
each device you want volume to be unlocked.
5. Now, after you select a device that has volume
unlocked (e.g.,CBL), pressing VOL+, VOL–,or
MUTE, will control the device’s volume only in
its own mode.
To Unlock All Volume Control (Global Volume
Unlock):
NOTE: Performing these instructions will set independent volume
control for all programmed devices (e.g., TV volume control in
TV mode,VCR volume in VCR mode, etc.).
1. On the remote control,press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9 - 9 - 3.
3. Press VOL+ once. The last-selected device key
(in step 1) will blink four times.
To Next Page
Loading...
Need help?
General
