MATERIAL SETTINGS GUIDE
Section 5-11
CORK
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 80 38 500 1 .010”
30 80 45 500 1 .010”
35 80 52 500 1 .010”
40 80 60 500 1 .010”
45 80 67 500 1 .010”
50 80 75 500 1 .010”
55 80 84 500 1 .010”
60 80 90 500 1 .010”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 12 4.0 500 1 .010”
30 10 4.0 500 1 .010”
35 9 4.0 500 1 .010”
40 8 4.0 500 1 .010”
45 7 4.0 500 1 .010”
50 6 4.0 500 1 .010”
55 5 4.0 500 1 .010”
60 4 4.0 500 1 .010”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 60 1.6 100 1 .060”
30 50 1.6 100 1 .060”
35 43 1.6 100 1 .060”
40 38 1.6 100 1 .060”
45 33 1.6 100 1 .060”
50 30 1.6 100 1 .060”
55 27 1.6 100 1 .060”
60 25 1.6 100 1 .060”
COMMENTS
Cork is not very popular for engraving but it does engrave and cut nicely. Cork is mainly used for making
gaskets by vector cutting the gasket patterns.
LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING AND SPARKING. Use
caution when attempting to cut this material. It would be better to use a longer focal
length lens to prevent the lens from being damaged during processing. NEVER leave
the machine unattended while processing any material. Damages caused by
processing any material ARE NOT covered under warranty.
To Next Page
Loading...