Universal Remote Control R7 - Page 24

ОМ (6
Button | ———
(о) (со) (vcr) (aux) Í
COMPONENT
Buttons
сто сэ
STEP 3: Once vou've entered all the Power Оп commands, press the
CHANNEL UP button to save your MacroPower commands and the
component button LED light will blink three times to confirm the
programming.
CHANNEL UP
Button
SUGGESTION: Most of the components have the same signal to turn
the power On and Off. You may want to program MacroPower only in
the ON button and save the SYSTEM OFF button to turn components
On or Off individually.
Note: If you want to program MacroPower for the SYSTEM OFF button,
repeat the same steps used for POWER ON programming.
22