Universal Remote Control R7 - Finding Component Set-Up Codes; Retrieving Codes Used in Auto-Search

Finding a Device Button's Set-up Code Number
If you used the Auto-Search Method to program a component, you
may not actually know what the correct code number is.
Here is a way for you to identify what that code number is, so you
can make a note in the back of this Manual for future reference.
STEP 1: Press and hold the SEL and the desired Component button
you would like to verify for approximately three seconds until the
Component LED light turns on.
COMPONENT
Buttons
SELECT
Button
IMPORTANT: If you don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and you will need
to start over.
25