Universal Remote Control R7 User Manual

SECTION 2: Pre-Programmed Auto-Search Method
The Auto-Search Method is а мау vou can scan through other
codes in the table to find the right code for vour component.
STEP 1: Using vour old remote, turn on the component vou want to
program with the R7, let's sav vour TV.
STEP 2: Now, press down on the Component button, (in this case
the button that savs TV), and the SELECT (SEL) button at the
same time. Hold them both down for 3 seconds until the TV
component button LED light turns on.
IMPORTANT: If you don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and vou will need
to start over.
STEP 3: Press the UP ARROW button once. Each time the Up
Arrow is pressed, the code will count up one code number and
send a Power OFF signal. When the correct code is sent out, the
component will turn off.
UP ARROW
Button

Universal Remote Control R7 Specifications

General

Brand	Universal Remote Control
Model	R7
Category	Remote Control
Language	English