Universal Remote Control R7 - Erasing Remote Commands and Settings; Erasing a Single Learned Command

Erasing Commands - Оуегмем
You can erase a single learned command, all learned commands in
each component mode, SimpleSound programming, MacroPower
commands, or re-set the remote to original factory default settings, if
desired.
SECTION 1: Erasing a Single Learned Command
STEP 1: To erase a single command, press and hold both the
component button and the ENTER (ENT) button together for about 3
seconds until the component LED light turns on.
COMPONENT
Buttons
ENTER (ENT)
Button
d
= UNIVERSAL”
R7
IMPORTANT: If you don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and you will need
to start over.
27