Universal Remote Control R7 - Erasing All Learned Commands for a Component

The R7 Remote Control
SECTION 2: Erasing АП Learned Commands from
One Component Mode
This function allows vou to erase all the learned commands from one
component. For example, if vou want to erase all learned commands
on the TV component button because vou bought a new TV, the
process is verv simple.
STEP 1: Press and hold both the desired component button and the
ENTER (ENT) button at the same time for about 3 seconds until the
component LED light turns on.
IMPORTANT: If vou don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and vou will need
to start over.
PAUSE
Button
ENTER (ENT)
Button
fi
STEP 2: Press and hold both the desired component button vou
want to erase and the PAUSE button for about three seconds, until
the component LED light blinks twice to confirm the erasure.
STEP 3: To exit, press and hold both the component button and the
ENTER (ENT) button until the component LED light blinks three
times.
29