If the Learning Method does not
work, here are a few suggestions:
• Infrared (IR) beams on all remotes are
sensitive to light, and can be impacted
several ways. Here are some things to
look out for:
– If you have a Plasma TV, move
farther away from it or to another
room while working with the remotes.
– Avoid programming under fluorescent
light or direct sunlight. Close your
curtains during the day.
– If you have a glass top or metal table,
put a cloth between the table and the
remotes to reduce reflections. It’s a
great use for your black t-shirts.
• Put new batteries in the old remote.
• Gradually vary the distance between the
two remote controls.
• Adjust the angles of the remotes (i.e.,keep
the URC-SR3 on a flat surface while holding
the other remote in hand and angling it
down toward the URC-SR3)
• Tap and release the button on your old
remote instead of pressing and holding the
button down
Here are some additional facts
regarding the learning process:
• Learned functions override any existing
preprogrammed functions on the remote
control
• Learned functions are automatically erased
when a new function is learned on the
same button
• Learned functions are retained even after a
different set-up code number is programmed
into the remote control
• To return to an original pre-programmed
function, a learned function must be erased.
See page 28.
Page | 16
To Next Page
Loading...
Need help?
General
