Page | 25
Channel Control Punch Through
This punch through lets you set up the URC-
SR3 remote so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will operate in other component
modes on the remote control.
STEP 1: Press and hold the component
button you want to add channel control to,
such as [DVD], and the SELECT [SEL] button
at the same time for two seconds until the
Component light turns on.
Release the buttons.
STEP 2: Press the CHANNEL UP [CH
5
] button.
The component LED light will blink once.
NOTE: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step one.
STEP 3: Press either the [TV] or CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink two times to confirm it is saved.
SELECT
CH
COMPONENT
BUTTONS
To Next Page
Loading...
Need help?
General
