Erasing Commands - Overview
If you have set up your macros and punch
throughs, you should be able to put all your
other controls away for safe keeping.
However, you may find one pesky control you
want to change or get rid of. The URC- SR3
allows you to erase commands easily.
You can erase a single learned command, all
learned commands in each omponent mode,
SimpleSound programming, MacroPower
commands, or re—set the remote to original
factory default settings.
These next few pages walk you through the
process.
Erasing a Single Learned Command
from One Component
STEP 1: Press the component button where
the learned command is stored and the [ENTER]
button at the same time for two seconds until the
component LED light turns on.
STEP 2: Press and hold the button you want
to erase for two seconds. The component light
will blink twice to confirm the erasure.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode, and
you will have to start over with step one.
STEP 3: Repeat Step 2 to erase any other
buttons in the selected component mode.
STEP 4: To exit Erase mode, press and hold
both the component button and the [ENTER]
button at the same time until the component
light blinks three times.
Page | 28
ENTER
COMPONENT
BUTTONS
To Next Page
Loading...
Need help?
General
