Page | 30
Erasing MacroPower & Other
Macro Commands
STEP 1: To erase MacroPower commands on
the POWER [ON] or [SYSTEM OFF] button,
press and hold either the POWER [ON] or
[SYSTEM OFF] button and the [MUTE] button
simultaneously for two seconds until the current
status Component light turns on.
STEP 2: Press the CHANNEL UP [CH
5
]
button to erase and exit Erase mode. The
component light will blink two times to confirm
the erasure.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode,
and you will have to start over with stepone.
SELECT
CH
5
ALL OFF
POWER ON
To Next Page
Loading...
