Universal Remote Control WR7 User Manual

Page | 26
Channel Control Punch Through
This punch through lets you set up the WR7
remote so that either the Cable or TV Channel
Controls (CHANNEL UP, DOWN, LAST,
CHANNEL NUMBERS 0-9, +10 and ENTER)
will also operate in other component modes on
the remote control.
STEP 1:
Press and hold the component
button you want to add channel control to, such
as [DVD] or [VCR], and the SELECT [SEL] button
at the same time for two seconds until the
Component light turns on. Release the buttons.
STEP 2: Press the CHANNEL UP [CH
5
]
button. The component LED light will blink once.
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set up mode, and you
will have to start over with step one.
STEP 3: Press either the [TV] or [CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink three times to confirm it is saved.
COMPONENT
BUTTONS
SELECT
BUTTONS

Universal Remote Control WR7 Specifications

General

Brand	Universal Remote Control
Model	WR7
Category	Universal Remote
Language	English