4. Checking the electric connections
- Check that the actual AMPs
absorbtion of every phase is the
same as the one reported in the
technical data sheet.
- Check the absence of electrical
leakage.
- Check the continuity between the
wall of the unit and the ground wire.
- A digital multimeter is
reccomended in performing this
operation.
- Before the shipment an accurate
test is made to grant the security of
the oven. It is anyway recommended
that all these checkings are made to
grant the security and to verify the
correctness of the electrical
connections.
Technical
Data
Sheet
14
To Next Page
Loading...
Need help?
General