13. Unox reverse osmosis
Installation
- Electrical Connection: same procedure of
ovens.
- Water connection (water inlet):
- It is necessary to place a shut-off valve
between the water system and the
appliance.
- Disconnected the pipe from the oven
and connected to the water inlet of the
reverse osmosis system (you find a Ǿ 8
mm quick connection on the reverse
osmosis system).
- Before connecting the water pipe to the
appliance please let some water flow to
clear the pipe of any obstructions.
- In case of the inlet pressure is under 4
bar, add a pressure reducer setted to 2
bar.
- Water connection (outlet water):
- Connect the treated water outlet
(“TREATED WATER”) to the oven inlet by
using the Ǿ 8 mm pipe supplied.
- The waste water outlet (“WASTE
WATER”) has to be connected to a water
drain using the Ǿ 6 mm pipe supplied.
- Because of sudden pressure changes that
may occur this pipe can move: for this
reason it has to be firmly fixed to the
water drain.
- Connection to the oven:
- The reverse osmosis system is
connected to the oven through the RJ45
connectors that are located at the rear of
the oven.
Water Connection
WATER INLET
TREATED WATER
WASTE WATER
43
To Next Page
Loading...
Need help?
General