Unox ChefTop 5 Series User Manual

1. Breakdown Messages (Series 4)
OVEN
- Breakdown messages on the
control board:
- Oven
Breakdown messages of oven
59
ERROR DESCRIPTION EFFECT POSSIBLE CAUSES SOLUTION
The connection wires of the chamber
probe 1 are disconnected from the
power card
Check the electrical circuit connection
Damaged cavity probe 1 Check and eventually replace the probe
Damaged power card Replace power card
The connection wires of the cavity probe
2 are disconnected from the power
board
Check the electrical circuit connection
Damaged cavity probe 2 Check and eventually replace the probe
Damaged power card Replace power card
The connection wires of the core probe
are disconnected from the power card
Check the electrical circuit connection
Damaged core probe Check and eventually replace the probe
Damaged power card Replace power card
The minimum distance between free
room and the appliance is not respected
Keep the minimum distance between
ovens and walls as suggested in the
Unox instruction guide (5 cm to 10 cm)
Defective capacitor - the motor takes
longer to reach the normal speed,
vibrations, etc
Check and eventually replace the
capacitor
Damaged motor bearing Replace the motor
Damaged power card Replace power card
The sensor has detected a temperature
over 318°C in the external part of the
chamber - even if the probe was setted
to lower temperatures
Check the effective chamber
temperature:
- if the oven probe is right the Safety
Termostat is defective and it should be
replaced
- if the temperature misured by the oven
is wrong a probelm occurred in the
chamer probes, refer to EF1 or EF2 for
the diagnosys and fixing.
The sensor has detected a temperature
over 318°C in the external part of the
chamber - when the chamber
temperature was setted to approx 300
°C
Control that the minimum distance
between ovens and walls as suggested
in the Unox instruction guide (5 cm to 10
cm) is respected
Control board / Power card connecting
cable is damaged or disconnected
Check and eventually replace the
connecting cable
Damaged power card Replace power card
Cable connection (RJ45) between oven
and accessory is damaged or
disconnected
Check and eventually replace the RJ45
cable
Damaged power card of accessory Replace power card
EF1
Break down of the
electric circuit of
the chamber probe
1 (rear)
The unit uses the chamber
probe 2 (if this one is broken
too, the oven stops and it's
not possible to restart it. The
display shows the letters
EF1)
EF2
Break down of the
electric circuit of
the chamber probe
2 (front)
The unit uses the chamber
probe 1 (if this one is broken
too, the oven stops and it's
not possible to restart it. The
display shows the letters
EF2)
EF3
Break down of the
electric circuit of
the chamber core
probe
Impossible to set heart
temperature and use the
programmes that use the
core probe
EF4
Motor thermal
protection
intervention
The oven stops and it's not
possible to restart it again
EF5
Safety thermostat
intervention
The oven stops and it's not
possible to restart again
EF6
Break down of the
electric circuit of
the power board
The oven stops and it's not
possible to restart again
EF7
Loss of
communication
between oven and
connected
accessories
The accessory doesn't starts

Unox ChefTop 5 Series Specifications

General

Brand	Unox
Model	ChefTop 5 Series
Category	Oven
Language	English