Uponor Smatrix Base Pro Quick Guides

Safety instructions
This quick start guide to serves as a reminder for
experienced installers. We strongly recommend reading
the full manual before installing the control system.
Controller
Wa rni ng!
The Uponor system uses 50 Hz, 230 V AC
power. In case of emergency, immediately
disconnect the power.
Wa rni ng!
Electrical installation and service behind
secured 230 V AC covers must be carried
out under the supervision of a qualified
electrician.
Wa rni ng!
The transformer module is heavy and might
detach if the controller is held upside down
without the cover on.
Cau ti on!
To avoid interference, keep installation/data
cables away from power cables of more than
50 V.
Cau ti on!
Ensure that each actuator is connected to the
correct channel so that the thermostats are
controlling the correct loops.
NOTE!
Wires between transformer and controller card
needs to be disconnected prior to detaching.
NOTE!
Connect only one actuator for each channel.
Channels 01 and 02 have double outputs (a
and b) for two actuators.
Thermostat/System device
NOTE!
Registration of at least one thermostat must
be done before registering a system device.
NOTE!
Up to 16 controllers can be registered to an
interface.
Cau ti on!
If more than one controller is available in the
system, register the thermostat as a system
device to the master controller.
Cau ti on!
The switches in public the thermostat must
be set before the thermostat is registered.
Cau ti on!
The switches, in the public thermostat, must
be set to one of the available functions,
otherwise it cannot be registered.
QUICK GUIDE
3
UPONOR SMATRIX BASE PRO · QUICK GUIDE
EN
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SI
SK

Uponor Smatrix Base Pro Specifications

General

Brand	Uponor
Model	Smatrix Base Pro
Category	Controller
Language	English