Uponor T-75 - Base Unit Installation; Preparation Before Installation

www.uponor-usa.com • www.uponor.ca
4
Uponor Climate Co˘ntrol™ Zoning System Installation Guide
5
Uponor Climate Co˘ntrol Zoning System
Components
Thermostat
DisplayT-75
Base Unit C-55
Antenna for
Base Unit C-55
Section 3
Base Unit Installation
Base Unit Diagram
Preparation Before Installation
Review the wiring diagram located inside the base
unit cover.
Verify Contents
• Cordless electric drill
• 6mm (1¼") drill bit
• Small athead screwdriver
• Phillips screwdriver
Review Drawings
Review the drawings of the radiant oor heating system.
If the locations of the base units and thermostats are not
specied, determine the best positions.
• Install base unit with antenna close to each manifold.
• A 110VAC standard power receptacle is required for
the connection of the base unit.
• Protect the mounting locations for the Zoning System
from moisture.
• Use one thermostat for every zone with radiant
oor heating.
Base Unit C-55
Base Unit C-55
Antenna
Installation guide
Fastening screws
Adhesive strip
Connection cable
for antenna (1 ft.)
Connection cable
for antenna (10 ft.)
Connection cable
for interface
Interface
Language data stick
Interface bracket
Thermostat display T-75
Batteries
Ta ble stand
Wall bracket
Adhesive strip
Fastening screws
Thermostat
Display T-75
Thermostat
Mounting Kit
forT-75
Te rminal block for connection
of antenna and extensions
for additional I-75 interface
Interface RJ 9
connector for I-75
Push button and LED from
01 to 12 for channel registration
Te st button with LED
Quick connectors for
the actuators
Socket for the connection
of the data stick
Power LED
110v/60Hz Compartment – Heat-demand Relay
110V
0201
110V
A3601012 C-55
IP30
T55
Made in France