- 11 -
3
Getting Started
3.1 Taking a Measurement
- 12 -
3.1 Taking a Measurement
This section describes how to get started by taking a quick measurement. Note that
some of the references to buttons and lights are described in the Product Description
section.
Turn on the MK350S by pressing the
On/Off button. A green light on the same
side as the On/Off button will illuminate.
1
The unit will ask you if you want to
perform a “Dark Calibration”. Tap “Yes”.
2
When Dark Calibration is finished, tap
“OK” again.
4
The unit will then ask you to place the
“Sensor Cover” over the sensor. Place
the cover over the sensor and tap “OK”.
3
To Next Page
