38
Setting Printing Position Adjustment: up/down (0–9)
(code 08)
When you initially set up your clock, you may skip
this step. This setting can be changed later if you nd
that the printing alignment is off. If the alignment is
incorrect, you can adjust the position on the time
card where the punches will print. When the code
“08” appears, set the position (up/down) where the
punch will print. Use the + and – buttons to make
your selection, then press Enter to conrm the
setting.
NOTE: It is recommended that you leave this setting
at the default.
Setting Printing Position Adjustment: right/left (0–9)
(code 09)
When you initially set up your clock, you may skip
this step. This setting can be changed later if you nd
that the printing alignment is off. If the alignment is
incorrect, you can adjust the position on the time
card where the punches will print. When the code
“09” appears, set the position (right/left) where the
punch will print. Use the + and – buttons to make
your selection, then press Enter to conrm the
setting.
NOTE: It is recommended that you leave this setting
at the default.
HN3—Alarm Options
The HN4000 allows you to set up to 12 alarms during
the week. You can set up alarms to signal the beginning
and end of shifts and the beginning and end of breaks.
At the designated time, the HN4000 will play the internal
alarm music or ring an external bell, which is purchased
separately.
Setting the Duration of the Alarm (code 00)
Under the HN3 menu, when the code “00” appears, set
the duration of the alarm time (in seconds). Use the +
To Next Page
Loading...
Need help?
General
