UREVO URTM006 - TROUBLESHOOTING; Failures and solutions

22
short-circuit
protection
(Antiexplosion
protection)
2.Excessive torque setting.
3.Replace the motor or host controller.
E6
Main motor
abnormality
protection
1. Check whether the motor wire is connected.
2. Replace the motor.
3. Replace the host controller.
E7
Communication
error
1. Replace the 5P communication line of the
display board.
2. Replace the display motherboard.
3. Replace the host controller.
E8
Overload
protection
1. Rule out the cases of overweight, shortage of
oil on the running belt or running board.
2. Replace the running belt or running board.
3. Replace the motor.
4. Replace the host controller.
TROUBLESHOOTING
Failures and solutions
This product is reliably designed and easy to use. In case of a problem, carefully read the
solutions to the failures as described below.
Failure: No information is displayed on the screen.
Solution: Check whether the power cord is plugged in properly, whether the plug is
loose, and whether the power switch is turned on.
Failure: Power outage during use.
Solution: Check whether the power cord is connected firmly and whether the
overcurrent protector is disconnected.
Failure: Running belt is not centered.
Solution: Check whether the treadmill is placed on flat ground and whether the running
belt is adjusted properly. Refer to the adjustment of running belt.
If the problem in your treadmill is not included in the above, and you are not sure
how to solve it, please contact us(Email: Services@urevosports.com) timely and do
not handle it by yourself.