DS1093-184A 34
4 BASIC CONFIGURATION
4.1 IP CAMERA CONFIGURATION BY MANUAL ASSIGNMENT
1. If the Hybrid DVR is connected to a LAN where a DHCP service is active, a valid IP address will automatically be
assigned to the Hybrid DVR. To check the IP address assigned to the Hybrid DVR by the LAN network, perform as
follows:
o Access the Hybrid DVR OSD menu by pressing the right mouse button and enter the administrator
password (default: 00000000)
o In the page [Main Menu Parameter Network] display the Hybrid DVR current network
parameters: wait about ten seconds for assignment and automatic display of network parameters.
o If the LAN network doesn’t support the DHCP service, in the Hybrid DVR page [Main Menu
Parameter Network] change from DHCP mode to “Static” mode, then manually enter the suitable
network parameters: IP address, Mask, Gateway, DNS.
IMPORTANT: to prevent video loss on the IP channels, make sure IP cameras have a static IP address configured.
2. Assign IP cameras in the LAN network to Hybrid DVR channels. The assignment can be manually performed by
pressing the button [+].