Need help?Do you have a question about the urmet domus Miwi 955/40 and is the answer not in the manual?
General| Type | Video Intercom |
|---|---|
| Mounting | Wall-mounted |
| Colour | White |
| Camera | Yes |
| Night Vision | Yes |
| Handsfree | Yes |
| Housing Material | Plastic |
Specifies maximum distances between devices based on wire cross-sections.
Provides essential safety and procedural information for electrical connections.
Instructions on using Dallas keys for door opening.
Configuration settings for the LU line.
Resets EEPROM memory and restores default programming.
Restores specific default settings (P1, P2, P7).
Management of logical user and opening codes.
Programming logical user codes for the system.
Allows reprogramming or remapping of logical user codes.
Programming individual opening codes for users.
Programming general opening codes for keyboards.
Programming Dallas keys for user access.
Updates the software for the call module keyboard.
Details how to adjust the panel using potentiometers.
Details how to adjust the panel using potentiometers.
Step-by-step guide for activating the system in MASTER mode.
Activation steps for systems configured in MASTER/SLAVE mode.
Instructions for operating and programming video signal transmission.
Method to access programming mode in case of forgotten password.
Explains how to initiate calls to users within the system.
Describes how to use general codes for door opening.
Explains the usage of individual codes for door opening.
Overview of the system's programming mode and its interface.
Details the structure and navigation of the programming menu.
Configuration settings for the LU line.
Main setup options for the system.
Settings related to time parameters.
Configuration settings for MASTER/SLAVE functions.
Explains how to navigate and use the programming mode.
Restores default settings for the LU line configuration.
Primary setup options for the system.
How to edit and change the system's access password.
Procedure to edit the unique ID number of the call module.
Configures the mode of operation for general opening codes.
Configures the mode of operation for individual opening codes.
Sets the duration for which the electrical lock remains active.
Configuration settings for MASTER/SLAVE functions.
Modifies the ID number of the MASTER power supply.
Programs logical user codes for the main communication channel.
Remaps logical user codes from the additional channel to the main channel.
Details how to configure the bracket using dip-switches.
Describes the programming procedure for the video distributor.
Details how to set the physical address for the decoder outputs using dip-switches.
How to set the unique ID number for the digitizer using dip-switches.
Details the programming process for the digitizer.
Associating buttons with door phones and setting power unit/riser.
Provides detailed technical specifications for the switchboard station.
Configures time and date for service switching.
Configuration settings for the switchboard station.
Restores the switchboard station to its default settings.
General operating instructions for the switchboard station.
Lists and explains error messages that may appear on the display.
Wiring diagram for a single main audio entrance panel system.
Wiring diagram for an extended main audio entrance panel system.
Wiring diagram for three main audio entrance panels using UTP and distributors.
Wiring diagram for an analogue entrance panel system with a digitizer.
Wiring diagram for three analogue entrance panels with digitizers.
Wiring diagram for a single video entrance panel using coax cable.
Wiring diagram for a video entrance panel using coax and distributors.
Wiring diagram for a single video entrance panel using UTP cable.
Wiring diagram for decoder 1052/34 using UTP and distributors.
To Next Page