IM 50.560CA UA (B/4-03)
DEPOLOX
®
3 PLUS RESIDUAL ANALYZER
10
2.1.4 Select Sensor Types
The setting for the measuring signal of the disinfection sensors must
correspond to the connected sensor. Select the sensor at the ten-position
DIP switch S3 on the board (factory setting is for Bare Electrode).
WARNING: WRONG SETTING CAN CAUSE DAMAGE TO THE
SENSOR AND TO THE DEPOLOX 3 PLUS.
!
Figure 2.2 - DIP Switch
3-Elect. “Depolox 3 plus”
(Bare Electrode):
2-Elect. “old Depolox 3”:
All membrane sensor:
45678910
OFF
45678910
OFF
45678910
OFF
To Next Page
Loading...