IM 50.560CA UA (B/4-03)
DEPOLOX
®
3 PLUS RESIDUAL ANALYZER
Introd. (Cont'd)
Options:
• Flow switch (to provide alarm for loss of sample water)
• Stop valve (to shut off sample flow)
• Impedance transformer (for pH or Fluoride probe)
NOTE: When ordering material, always specify model and serial
number of apparatus.
Electromagnetic Compatibility and Other Requirements
DEPOLOX 3 plus devices conform with the following requirements:
• Generic standards EN 50081-1 (emission)
• EN 55022 Class B
• EN 50082-2 (immunity)
• EN 61000 -4- 2, 3, 4, 5, 6, 8, 11
DEPOLOX 3 plus devices are designed for use in industry, as well as the
domestic, business, and trade sectors.
Declaration of Conformity
DEPOLOX 3 plus devices comply with the requirements of the EU direc-
tives 89/392/EC “Machinery Directive”, 73/23/EC “Low Voltage Direc-
tive” and 89/336/EC “Electromagnetic Compatibility” and the harmo-
nized European Standards listed therein.
Intended Use
The DEPOLOX 3 plus consists of one or two combined measuring and
reference sensors for chlorine, chlorine dioxide, ozone, pH, and fluoride;
a measuring water monitoring device; and an electronics module. The
system is for measuring the concentration of chlorine, chlorine dioxide,
and ozone as well as pH and fluoride, and to display and transmit measure-
ments, in potable water.
Refer to the permissible measurement combinations, for a single unit, as
mentioned previously.
To Next Page
Loading...