To Next Page

To Previous Page

DC APPLICATION

The DC terminals may be used for charging 12V automotive-type batteries only

1.Connect the charging cables to the battery terminal.

2.Start the engine and charge the battery

An overloaded DC circuit will trip the DC circuit breaker

(push button comes out) If this happens. Check the short

circuit or counter connection and wait a few minutes

before pushing the circuit protector.

NOTE:

3.Stop the engine, then disconnect the

charging cables in the reverse order of

connection.

1.Turn off all electrical appliances.

6.STOPPING THE ENGINE

2.Turn the engine switch

to the OFF position.

3.Disconnect the electrical

appliance.

4.Turn the fuel valve to the

OFF position.

NOTE:

To stop the engine in an emergency,turn the engine switch OFF.

1ON2OFF

- 7 -

Questions and Answers:

Need help?

Do you have a question about the UST GG5500 Series and is the answer not in the manual?

UST GG5500 Series Specifications

General