2LV/2L1/2L2/2MS/2MT
1-5-1
1-5 Assemb ly and disassembly
1-5-1 Precautions for assembly and disassembly
(1) Precautions
Before starting disassembly, push the power switch and check the disappeared display of an operation panel
certainly. Unplug the power cable from the wall outlet.
When handling PWBs (printed wiring boards), do not touch parts with bare hands.
The PWBs are susceptible to static charge.
Do not touch any PWB containing ICs with bare hands or any object prone to static charge.
When removing the hook of the connector, be sure to release the hook.
Take care not to get the cables caught.
To reassemble the parts, use the original screws. If the types and the sizes of screws are not known, refer to
the PARTS LIST.
(2) Drum unit
Note the following when handling or storing the drum unit.
When removing the drum unit, never expose the drum surface to strong direct light.
Keep the drum unit at an ambient temperature between -20°C/-4°F and 40°C/104°F and at a relative humidity
not higher than 85% RH. Avoid abrupt changes in temperature and humidity.
Avoid exposure to any substance which is harmful to or may affect the quality of the drum unit.
Do not touch the drum surface with any object. Should it be touched by hands or stained with oil, clean it.
(3) Toner
Store the toner containers in a cool, dark place.
Avoid exposing the toner containers to direct light and high humidity.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
