4-113
Operation Panel
The options available in Netwk Auth. Set are as follows:
• Server Type (Server type selection)...4-113
• Host Name (Entering of Host Name)...4-113
• Port (Port number setting)...4-113
• Domain Name (Entering of Domain Name)...4-114
Server Type (Server type selection)
Select the type of server for the authentication server.
1 In the Netwk Auth. Set menu, press or to select Server
Type.
2 Press [OK]. The Server Type screen appears.
The available server types are as follows:
NTLM
Kerberos
Ext.
3 Press or to select the desired server type.
4 Press [OK]. The server type is set and the Netwk Auth. Set menu
reappears.
Host Name (Entering of Host Name)
Enter the host name for the authentication server.
1 In the Netwk Auth. Set menu, press or to select Host Name.
2 Press [OK]. The Host Name screen appears.
3 Enter the host name using the numeric keys.
4 Press [OK]. The host name is registered and the Netwk Auth. Set
menu reappears.
Port (Port number setting)
Set the Port number for the authentication server.
1 In the Netwk Auth. Set menu, press or to select Port.
2 Press [OK]. The Port screen appears.
Note Select Ext. to perform ID Card Authentication.
Note Up to 64 characters can be entered. For details on
entering characters, refer to Character Entry Method on page
A-2.
To enter the IPv6 address, enclose the address in brackets [ ].
(e.g., [3ae3:9a0:cd05:b1d2:28a:1fc0:a1:10ae]:140)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
