Utax P-5531DN

Preparation before Use
2-4
5 Press [OK]. The Wired Netwk. Set menu screen appears.
Checking that TCP/IP is On
This is an explanation of the method for setting for IPv4, but TCP/IP should also be On when setting for IPv6.
6 Select TCP/IP Settings and press [OK]. The TCP/IP Settings
menu screen appears.
7 Press  or  to select TCP/IP.
8 Press [OK]. The TCP/IP screen appears.
9 Check that On is selected. If Off is selected, then press  or  to
select On.
10Press [OK]. The TCP/IP setting is set and the TCP/IP Settings
menu reappears.
Switching DHCP to Off or On
Select On when using a DHCP server to automatically obtain an IP Address. Select Off to enter an IP Address.
11Press  or  to select IPv4 Setting.
12 Press [OK]. The IPv4 Setting menu screen appears.
13 Press  or  to select DHCP.
Wired Netwk. Set:
TCP/IP Settings
Exit
LAN Interface
01
02
TCP/IP Settings:
IPv6 Setting
Exit
03
IPv4 Setting
02
01
TCP/IP
TCP/IP:
Off
01
On
02
*
Note "*" is displayed for the setting which has been
selected.
TCP/IP Settings:
IPv6 Setting
Exit
03
IPv4 Setting
02
01
TCP/IP
IPv4 Setting:
DHCP
Exit
01
Auto-IP
02
IP Address
03