TTo prevent burns, o prevent burns, when the waterwhen the water
temperature of the engine is higher than 70temperature of the engine is higher than 70
°°
C, DO NOT open the pressure cap of theC, DO NOT open the pressure cap of the
radiator.radiator.
The engine coolant fluid is designed to preventThe engine coolant fluid is designed to prevent
rust and freezing/overheating. Seerust and freezing/overheating. See
《《
Table for the oilTable for the oil
used in the truckused in the truck
》》
..
2. Front-wheel bearing change and 2. Front-wheel bearing change and lubricationlubrication
See the drive axle wheel contents in theSee the drive axle wheel contents in the
Maintenance Manual.Maintenance Manual.
3. Rear-wheel bearing change and 3. Rear-wheel bearing change and lubricationslubrications
See the steering axle contents in the MaintenanceSee the steering axle contents in the Maintenance
Manual.Manual.
4. Change steering axle gear oil4. Change steering axle gear oil
Put the truck on level ground. Put transmission inPut the truck on level ground. Put transmission in
neutral, shut off engine.neutral, shut off engine.
（（
11
））
Remove the oil plug, put oil to a case. Clean oilRemove the oil plug, put oil to a case. Clean oil
plug.plug.
（（
22
））
Install oil plug.Install oil plug.
（（
33
））
Remove breather plug and oil fluid position plug.Remove breather plug and oil fluid position plug.
Put the oil from orifice bend to steering axle shell untilPut the oil from orifice bend to steering axle shell until
oil overflows from level plug.oil overflows from level plug.
（（
44
））
Press level and install breather plug.Press level and install breather plug.
（（
55
））
StartStart--up forklift. Run engine let the steeringup forklift. Run engine let the steering
wheel control handle at neutral.wheel control handle at neutral.
（（
66
））
TTake out level plug. ake out level plug. Keep oil level Keep oil level until overflow.until overflow.
5.6 Others5.6 Others
1. Fuse and Relay1. Fuse and Relay
Fuse and relay are fixed in the control box near theFuse and relay are fixed in the control box near the
battery.battery.
Please replace old fuse with fuse with the samePlease replace old fuse with fuse with the same
capacity.capacity.
2. Change of tires2. Change of tires
!! WWaarrnniinngg
When using an aiWhen using an air compressorr compressor, first adjust the, first adjust the
air pressure of the compressor. Failure to do soair pressure of the compressor. Failure to do so
will cause a serious accident, since thewill cause a serious accident, since the
compressor delivers the maximum pressure.compressor delivers the maximum pressure.
To ensure safety, put the tire in a defendTo ensure safety, put the tire in a defend
casing while inflating.casing while inflating.
To Next Page
Loading...
