Page 10/10
HI 1 - E Manual v1.1.0.doc, AR, 15.06.2011 Glauburgstraße 34 D-63683 Ortenberg
Änderungen vorbehalten / All data are subject to alteration. welcome@uv-technik.com www.uv-technik.com
10. Declaration of conformity
uv-technuik meyer gmbh declares herewith that measuring instrument HI 1 carries the CE label and complies in full
with the requirements of EU directives relating to low voltage and to electromagnetic compatibility (EMC)
(89/336/EWG).
The following standards have been applied in evaluating the product.
Safety / security: EN 61010-1:2001
EMC: EN 61326: 2006
If a product is modified in any manner not agreed with us in advance, this declaration becomes void.
When using the sensor with an extension care must be taken to ensure that wiring is not laid alongside or close to
high-voltage power cables and that it is, if necessary, properly shielded so as to prevent spurious interference
being induced in the system.
The following advisory notes must be observed when operating the device :
Using the device in strong electromagnetic fields may aggravate measuring errors (<50 µV at 3 V/m and 1.5 meters
thermocouple sensor). After exposure to such irradiation ceases, the device will again operate within its technical
specifications.
To Previous Page
Loading...