UV-technik HI 1 - Peak value memory; Measured value memory; Relative measuring

Page 8/10
HI 1 - E Manual v1.1.0.doc, AR, 15.06.2011 Glauburgstraße 34 D-63683 Ortenberg
Änderungen vorbehalten / All data are subject to alteration. welcome@uv-technik.com www.uv-technik.com
Manual
8.3 Peak value memory
From the measured values acquired for each measuring point the highest and the
lowest values are continuously recorded. To display these high/low peak values
first the desired channel must be set and then the MAX or MIN key must be
pressed. As a check the display also includes the associated symbol.
To display the maximum value press key : MAX .
To display the minimum value press key : MIN .
To delete the maximum value press and hold down key : MAX .
To delete the minimum value press and hold down key : MIN .
To return to the measuring point display press key : M▲ .
As soon as you clear the memory, the current measured value will appear (because measuring is continuous).
8.4 Measured value memory
On the HI 1 any measured value can be saved.
To save the measured value press key : MEM .
The value most recently saved then appears in the function field preceded by the
symbol ´M´.
To return to the channel display press key : M▲ .
8.5 Relative measuring
One very useful function is to zero the measured value at certain locations or at certain times as a reference value
in order then to observe only the subsequent deviations. This function is independent of the locking status and
does not modify the programming parameters in the connector.
To zero-set the measured value press key : CLR .
To display relative measuring press arrow : REL.
To return to normal measured value press and hold down key : CLR .
Setting to zero automatically deletes the maximum and minimum values for this channel. The MAX, MIN,
and MEM functions are thus also available for relative measurement.
