Page 9/10
HI 1 - E Manual v1.1.0.doc, AR, 15.06.2011 Glauburgstraße 34 D-63683 Ortenberg
Änderungen vorbehalten / All data are subject to alteration. welcome@uv-technik.com www.uv-technik.com
8.6 Device configuration
On the measuring instrument a number of parameters can be configured. To do
so when switching ON press and hold down key
MEM
. The function field should
then show an abbreviation for the parameter and the main field should show the
value currently set.
To select from all possible parameters,
if any are available, press keys :
M ▲
or
M ▼
.
Locking the CLR key:
Automatic switch OFF time in minutes:
To enter a value first press :
ON
and the value starts flashing.
To modify the value press keys :
M▲
or
M▼
To delete parameters press :
CLR
Entry is completed by again pressing key :
ON
To terminate configuration at any time press key:
MEM
9 Technical data
System accuracy (resolution)
± 0,1 % of measured values ±3 digits
7 segments: Measured value 5 char, 15 mm
16 segments: Units 2 characters, 9 mm
-10°C...+60°C (continuous)
3 x AA alkaline batteries, 5 mA
approx. 10 mA without uv sensor.
With connected uv sensor SI 1 in total approx. 15 mA
ABS (acrylonitrile-butadiene-styrene)
Hand-held unit including 3 AA alkaline batteries, manual
Note: At the hand-held unit, different uv-sensors type SI 1 (e.g. for different uv bandwidths) can be connected one
after another. Only one hand-held unit for different sensors is required.
To Next Page
Loading...